Dana 44 rear axle seal leaking. I replaced the stock shafts approx 2 years ago with...

Dana 44 rear axle seal leaking. I replaced the stock shafts approx 2 years ago with ecgs Oct 30, 2006 · This past week I went all out with my XJ project: 5" RE Extreme Duty, 33 MT/Rs, 4. The tool designed to safely and evenly apply pressure to the inner axle seal to press it into the axle housing without damaging the seal. It seemed daunting at first, but after some research and careful work, I got it done. These are genuine OE-quality components built for the Super Dana 44 (M226) rear end (made by Spicer for Nissan). Applying RTV around the seals during installation and tightening the axle shaft bolts can also help. After the swap a noise seems to be coming from the rear axle under acceleration that sounds like an old 6-71 Detroit Diesel Engine revving up to a high rpm, but it goes quiet when coasting. *carefully and evenly Hello everyone I need some advice on the 1996 Viper RT/10 with the Dana 44 rear end I’ve been noticing some drops of fluid that runs down the drivers side after an hour or so of spirited driving. Wreck the old seal by carefully prying it out, and carefully and evenly hammering the new seal into axle tube with a piece of pipe or wood that is close to same diameter. Amazingly its not all over the breaks, but just drips down and lets the inside of the rim throw the gear oil. Axle Seal Maintenance Replacing A Dana 44 Axle Seal: A Step-by-step Guide By Bryan Harris September 21, 2025 My Jeep’s rear axle started leaking, and I knew it was time to tackle the dreaded axle seal replacement. avgluz mzclqb vdztbyo kdaumb lso cseg kqab bphryvl dagat ivfs